5  SLURS: 5, STAFF, POS1, HGT1, P5=HGT2, P6=POS2, P7, P8, P9, P10, P11
  
	P7=DIP(NT UNITS + OR -)
	P8 = 0=SLUR, 1=BRACKET, 2=LFT 1/2 BRKT, 3=RT 1/2 BRKT,
 
	FOR AUTOMATIC ALIGNMENT OF SLUR WITH NOTES, SET P13=1, THEN
	IF P8=-1, END POINTS WILL HOME TO NOTE CENTERS.
	IF P8=-2, END POINTS WILL HOME BETWEEN NOTES.
 
	USE P8=-3 TO HOME BETWEEN NOTES WHERE 1ST IS DOTTED.
 
	P9=CURVE FACTOR.  DEFAULT VALUE (0)=3  GIVES SLIGHTLY "FLATTENED"
	  SLURS. TO MAKE THEM MORE ROUND, DECREASE P9 TOWARD 2. 
	  TO RESTRICT THE CURVE TO THE END PORTIONS, INCREASE P9.
 
     IF P8=1 AND P9 IS NOT 0, A BRACKET WITH A NUMBER(P9) WILL BE DRAWN.
 
	HALF SLURS:  ADD 100 TO P7 FOR HALF SLUR WITH THE CURVE ON THE RIGHT.
	             ADD 200 TO P7 TO GET CURVE ON THE LEFT.
 
	SLUR WITH CHANGE OF DIRECTION:  ADD 300 TO P7 TO MAKE SLUR CHANGE
		DIRECTION.  IF P7 IS POS. THEN 1ST 'DIP' IS POS.; IF P7 IS
		NEG. THEN 1ST 'DIP' IS NEG.
 
   USE P10 TO SHIFT HIGH POINT OR 'CENTER' OF CURVE FROM MIDDLE. 
	P10=0 IS THE SAME AS P10=.5.  VALUES GREATER THAN .5 MOVE THE CENTER 
	TO THE RIGHT, LESS THAN .5 MOVE IT TO THE LEFT.  
	(VALUES GREATER THAN .75 OR LESS THAN .25 DO NOT MAKE GOOD CURVES 
	AS YET.)
 
   P11=1  WILL MAKE "DASHED" SLURS.  (THESE ARE RATHER ROUGH ON THE SCREEN
				      BUT THE PRINT-OUT IS GOOD.)